Search results

ok. I cleaned up the amp and now am getting some popping sounds in the front left channel (engine left) if I wiggle the lines going from CN6... these three lines lead to the front POT. Swapping CN5 and CN4 and I hear (seat left) popping. So the amp is doing something. lol. Maybe I should try and...

I made a speaker wire to go out of the M3 board to an external amp to see if FX were playing. sure enough, they are. So M3 board is ok. So I made a cable like above and tried to play my iPhone through the amp out the speakers, but nothing. Absolutely dead. Now I'm not hearing any static...

thanks I'm gonna give this a shot

The rear speakers I can slightly hear, and I mean slightly. adjusting volume doesn't increase hum. I changed the pot on the main speakers as well. so would I wire the 3.5mm jack and plug in some speakers? Not sure I follow.

Well, finally found some time and made an audio cable and plugged it from the the AMP to CN7 and CN8 on the model 3 board and got no sound. :(

so I tested the front POT. Checks out at 4.9k ohm. The rear pot is all over the place. 99, 200... this needs to be replaced. Also, I do hear hum in rear speakers. Would the one rear bad pot be killing all the sound? Have not tried connecting directly from amp to AM3 board, this is what you...

Well I didn't have it on VAC. Got 2 readings. On wire is 28.5 and the other is 18.5. Everything else on the D2 works.

just tested the cable to the transformer and it is reading 0.0 What can I do now?

Here's my AMP 838-13475. I tested the power on the CN1 cable which leads back to the transformer. With leads inserted I get 0.0. :( I don't see any fuses in between. So I think my original AMP is probably fine... it's just never had any power.

So I found replacement Amp for my D2 cab, but still no sound. I don't think the unit is even getting power. I see that it gets its power from the sub module. Anybody got some tips on how to troubleshoot this. It's the last remaining item on my D2. Works, but no sound :(

Tried to buy one from your website but all of my credit cards were rejected. DAYS LATER tried another CC and it worked.

bummer. didn't work. have to find a replacement amp.

thanks I'll give that a shot. :)

when I try and update this device it just says "updating". How can I tell what firmware is on it? is there some kind of command?

well I solved some issues. I soaked the drive board in Evaporust over night. I had noting to lose. And incredibly, doing this made the LED light come light up (they are a little crazy as they don't show full numbers, but it helped a little). Before hand I had cleaned with simple green, water...

I've got a Daytona 2 I've been refurbishing (regular edition, not BOE). It was a real mess. Now I'm discovering that I think some of the boards inside are corroded and not working. I already replaced the servo board because the traces were too corroded. The good news about my rig is Daytona 2...