Search results

Thanks xodaraP, knowing to unplug the wires then manually reboot after writing helped me get it running. I also used "OldCPS2BasePack". What would I need to do to make it auto reset? Thanks everyone! Literally got it working at midnight before I have a arcade party tomorrow!

I am using "Avalaunch_CPS2_for_Darksoft_Multi_150531" rom pack. I added a key file "ÿÿÿÿÿÿÿÿÿÿÿÿÿÿÿÿÿÿÿÿ" to each folder. Is that correct? Now when it says writing my screen goes black then when its done it goes dark blue. What wires if any do I need hooked up for unencyrpted roms?

I just soldered SW5 to pin 5 on C9 and nothing still. Where can I get the older firmware? Since I messed up the CLOCK pad on my PCB.

I think I have tried every rom pack. Is this is a real key " @ ¤ </ëàcÀ" and this is a blank one "ÿÿÿÿÿÿÿÿÿÿÿÿÿÿÿÿÿÿÿÿ" ? I also unsolderd my other 3 key writing wires just in case i had solder touching a near by component, like I have seen in couple threads on here.

Thanks guys, but its still a black or dark blue screen. I removed the battery and shorted the EX5 from the bottom of the board with a screw driver for a second while powered off. After looking trough this forum I decided to recheck my jumper settings. I found 2 that looked open but were shorted...

Thanks for the fast reply. I didn't even notice that connector was not symmetrical and I had it upside down! I flipped that connector and reseated the smaller board. I unplugged the 4 pin harness and tried booting unencrypted roms and it was more of a blank blue screen now. Im sure I have...

Hello I just received the CPS 2 multikit from https://www.highscoresaves.com/darksoft-cps2-multi-kit.html with the optional SD card. I used a working Marvel Super Heros on a Working A board. The board is a revision 6. I removed the battery and soldered some jumpers according to this SOOS SO...