What's new
By:

problem

  1. dillingerradio

    [RESOLVED: Missing Rainbow Cable] Donkey Kong Jr. (1982) - No Output

    [SOLUTION FOLLOWS] Shortly after posting I was shown a troubleshooting video which identified a rainbow cable as a crucial part (which was missing from my unit). I then sought out and purchased a replacement since I didn't have the proper connectors on hand to wire one up. Once it arrived, I...
  2. R

    Gaelco Smashing Drive Hardware Problem

    Hi all, I recently purchased a Gaelco Smashing Drive arcade main pcb from eBay. Unfortunately, the game doesn't start, there's no video output, only blinking LEDs. After reset or powering it up, one of the internal LEDs and the red LED on the back do flash for some time until the internal LED...
  3. MarBustelo

    Time Crisis Arcade Namco Problem with aiming

    Hello people, it's a pleasure to greet you, I'm new here, motivated by the fact that I've been with a mystery for months. 😓 After a move the gun stopped being able to point at the screen, we already checked cables and nothing was disconnected When shooting, the sight is always in the lower...
  4. arcadenostelgia

    Problems when upgrading an Raspberry Pi with Retropie and Emulation Station from generic joy/button kit to Sanwa / Happ kit

    We built this arcade box (below) from scratch in 2020, and my son decked it out with RGB lighting. It was a labour of love. We built the hardware with a RetroPie running on a Raspberry Pi (either 3 or 4) and Emulation Station. We picked up a cheap pack of joysticks and buttons and an XinMo2...
  5. 303george

    Electrohome g07 monitor help

    Hello! I'm wondering if anyone can give me some pointers on a few issues I'm having with this monitor. * I have some horizontal pinstripes (monitor is in vertical orientation in a centipede cabinet so they appear vertical on the screen but in actuality I think they'd be considered horizontal)...
    • 303george
    • Thread
    • centipede crt electrohome g07 issue monitor problem
    • Replies: 2
    • Forum: Monitor Help
  6. D

    Advice for wavy video interference on MVS

    Hello :) I'm getting wavy video (the picture waves back and forth) interference on my MV1F & MV1C using a Parsec Supergun when playing on my 2 CRT TVs (and on my LCD displays using a retrotink). View: https://youtu.be/2Kzdl9WlsM4 My setup is: Parsec Supergun (using the RGB (into a Retrotink...
  7. T

    Naomi 2 problem

    Hey everyone, by the end of last year, I was able to purchase a Sega Naomi 2 with a Raspberry Pi (PiForce Tools 1.5 installed) and a NetDimm (firmware 3.17) Since the whole real arcade hardware was new to me, I had to buy several additional items afterwards (which I didn't knew back then I...
Back
Top