deep
Student
Thanks !
3D Printed NAOMI Pi-Force LCD Housing
- Thread starter twistedsymphony
- Start date
Orders are open and the top post has been updated.
I still have a few colors to print as I currently have no red v2s and no white v1s I plan to have some by the end of the week if you're after one of those colors.
I still have a few colors to print as I currently have no red v2s and no white v1s I plan to have some by the end of the week if you're after one of those colors.
This case is *really* well done.
how is the fitment? whenever I build this stuff I'm always concerned about variations in people's hardware and if I allow enough "wiggle room" so it works for everyone. looking at your picture it looks like the LCD sits a bit lower than mine... mine is nearly flush.
Hm didn't notice that. I just made sure the buttons worked but I might be able to seat it a little closer. It could just be due to how I initially soldered that LCD onto the unit though. It all "feels" really tight and sturdy.
ArcadeMachinist
Professional
I wish someone would make slightly updated design to fit chinese clone of Adafruit's LCD keypad shield.
It has buttons centered under the LCD.
It works exactly as original one, but sometimes it is shipped with a shitty contrast pot, which you can easily replace.
But it's under $5 with free shipping, worth it IMHO.
Link to AliExpress
It has buttons centered under the LCD.
It works exactly as original one, but sometimes it is shipped with a shitty contrast pot, which you can easily replace.
But it's under $5 with free shipping, worth it IMHO.
Link to AliExpress
kingcar
Enthusiast
That does look nice.
The way the buttons are designed is ingenious.
The way the buttons are designed is ingenious.
Hi do you know where to DL the Chinese clone version's print file now?
Magus Incognito
Student
Anyone know where I might be able to purchase a 3d printed case for the adafruit lcd rgb plate & raspberry pi 3+???