FS 3D Printed Parts and Printing Services

[PASTBLASTER]

I get asked a lot to run parts for folks, so I decided with getting a new printer I can offer my parts and services to everyone.

Parts will be listed below with prices, but I can run your models for $3 an hour. Parts will be run in PETG or PLA / PLA+, color options are available.

Jamma Caps (Grey PETG): $2 each or 6 for $10.
Jamma Keys (Grey PETG) $.25 each or 5 for $1.
Arcade Panel Stands (Grey PETG) $6 per set.

Balltop Basic (Black PLA): $3.50
Balltop Pro (Black PLA): $4.00
30MM Stand (Black PLA): $2.50
Marquee Stands: $4 a set (2).

Shipping via USPS - Not included in the prices above.

More stuff will be coming soon!

 

[PASTBLASTER]

More stuff coming soon.

 

[RayBullty]

Nice job

 

[PASTBLASTER]

New stuff is here!

First up are two different Balltop display stands.

Balltop Basic: A Simple beveled base stand that can be used with various Balltop / Battop units that use the M6 thread type. These stands will come with the M6 screw so you just add your top to display. $3.50 each + shipping.

Balltop Pro: A dual sided display stand that allows tops with unique arts or badges to be displayed vertically or horizontally. The included M6 bolt is flush to the buttom of the base. $4 each + Shipping.

30MM Stand: A simple stand that allows any 30mm button to be displayed horizontally. $2.50 + Shipping (Please note, these have cracked under repeat installation and removal of snap in buttons. They have been printed a bit more solid to help with this, but it can happen over time). 24mm version can be made if there is interest!

Interest Check: I made a stand that allows a Shaft Cover and Dust washer to be used. Any interest in these? Will come with an M6 bolt that acts as a joystick shaft.

I am planning on running these in Black PLA. Other colors will be run in small quantities. All of these are made to order, but I try to ship within a week.

More to come soon...

-PB

 

[Maruchan]

Wanted to know if you can make this for me? Shipped to 92234 zip code

https://makerworld.com/en/models/2185664-vewlix-cp-bracket#profileId-2372602

 

[PASTBLASTER]

Caught up on all orders!

Added: Marquee stands: These are gapped for 3mm marquees (Please measure yours before ordering) These allow you to display a marquee on a flat surface like a shelf or desktop. $4 a set

Added more colors for my offerings.

Printers are open for a few days if you need anything ran.

More to come!

-PB

 

[only1eko]

I have a problem...
Didn't make it on the Xed & Mirko list.

Can you print the monkey ball banana for this stick?

It's not the same using the strike fighter handle.
Note: This is not the Gundam stick.

Edit: I hope this is close to the original, but here is the link:
https://www.printables.com/model/1408367-sega-naomi-monkey-ball-banana-shells

 

[PASTBLASTER]

Do you have a file for the Banana? If so , link it here or in DM and I can get you a quote for run time.

 

[RepairGuy95]

Do you do case sized prints?

 

[PASTBLASTER]

Do you do case sized prints?

My printer is 256mmx256mm so it can do roughly 10" prints. If the cases are sliced to accomodate that, I can.