Arcade monitor help !!!

[Goros_lair]

hello everyone if you can help me out itd be much appriciated. Okay i threw a 27inch crt in my z back thats ready for mvc2 everything worked fine with my other crt . Now its as if the image was cut in half and u swapped the pieces aroumd and kinda overlapped them a bit ive never had this issue before when i move the horizontal hold on the cjassis the image will fill the screen fully and go back to one image but itll be so fuzzy you cant see whats going on just that the image is not cut anymore or fliped then if h adjust back the screen becomes perfectly visable but is cut down the middle and flipped again . Ive tried every nob i can adjust on the chassis the focus also that my sync is right vertical and horizontal hold . Not sure whre to go next also tried multiple jamma games same problem wich leads me to believe its the monitor . Thanks for any insight !!!!

 

[Goros_lair]

 

[Mitsurugi-w]

Moved to Monitor Help section.

 

[Goros_lair]

thanks i just realised i posted that in the wrong spot !!

 

[brad808]

It's not syncing properly from the picture.

Are you trying to run a 31k signal on a 15khz monitor?

What is the monitor model number?

Let's see pics of how you have it wired in.

Composite sync?

 

[Goros_lair]

going down now to check out the monitor and take some photos !

 

[rewrite]

brad is likely right. Flip dip 1 on the Naomi the opposite way.

 

[Goros_lair]

Okay i got the image going now it was dipswitch one i honestlybthought itried that last night , the only problem im having now is adjusting the image to full screen i have two horizontal adjustments but it wont let me make the image big enough

 

[streetfighterken]

What brand is the monitor chassis? If it has a horizontal width coil, you can adjust that but typically you'll only get about 1/4 inch on both sides with it. If it's a Nanao MS8, it has a jumper for narrow/wide. If those solutions don't work, you can replace the width capacitor with a different value. All mentioned info can be googled.

 

[Goros_lair]

its a 27inch neotec 2701oFFK1005

dont see a horizontal width coil on this one

 

[Goros_lair]

CHS2701KFE001

 

[Mitsurugi-w]

DO NOT adjust the horizontal width coil with a metal allan wrench while turned on.

 

[Goros_lair]

my friend has quite a few monitors i think im gojng to switch him out of one that will be a bit more straight forward with adjustments for this game i read i can recap the horizontal section to allow further adjustment past the width coil and horizontal adjustment tabs on the controller and chassis but i dont want to risk ruining anything since i just bought this crt thanks for your help fellas i really appriciate it