Atari Battlezone Video Issue

Lastsix

Student
Joined
Nov 1, 2024
Messages
56
Reaction score
23
Location
United States
Fixed an electrohome for a battlezone cab and see this; Is this is an issue with the video hardware on the main pcb?
I don't know much about vector screens but am aware running for too long with a dot like this can damage the tube.

20261107_181237+1.jpg
20261107_192616+1.jpg
 
Does it look ok while playing on the scope outside of the retrace lines? Looks like you're seeing the retrace lines on the monitor, I'd see if you can read the voltage of the Z-signal off the board
1794257545706.png
 
Ok, so; ultimately screen was too bright and brightness and contrast did nothing. Pins 4 and 5 on connector p500 on the deflection board appear to be mismatched. The white wire pictured below is now on pin 5 and basically disconnected. Pin 4 is connected to pin 2 on the board and white wire goes to flyback power board.
Is it ok to run it like this?

20261114_170509+1.jpg
20261114_162218+1.jpg
 
Back
Top