Big Trouble with my TOSHIBA NANAO ms9

[Viku]

Hello! I have this problem on my TOSHIBA NANAO MS9. This very small copper wire from the yoke’s coil suddenly broke and now the image looks wrong. Do you think that it will work right again if I just solder it? Thank you so much

Photos & videos here:
https://photos.app.goo.gl/hTH8zdkjqBu9YVSy8

 

[thegreathopper]

I would solder it back, and It should work again.

 

[nem]

There's a coating on that wire, you can't just add solder to it. You will need to remove the coating with something abrasive, like sandpaper.

 

[Viku]

There's a coating on that wire, you can't just add solder to it. You will need to remove the coating with something abrasive, like sandpaper.

Thank you so much

 

[Viku]

Thank you so much. Any advices on how to sold it for Good? Do I need to follow a certain order of the 4 cables ?

 

[nem]

Looks like they all terminate to the same place, so order shouldn't matter. However, it's not like you could now know what wire was originally connected to where, so your guess is as good as any.

You likely need to get some extra magnet wire from somewhere unless you can pull the ends closer to each other.

 

[Viku]

SOLVED!!!! here's the tutorial:

https://twitter.com/victoralonso_es/status/1577616333142953986?s=20&t=Rx8OIgZuflASxxPcdUnkng