Isn´t it nice to finally give the
power house GNET all the games it deserved - AND - is able to DO ! Wooooo
Despite the SPU Shadow reads compared to FX hardware
Well, with the ram upgrade, it's more of a powerhouse

(maybe the games can go compressed, and extracted direct to ram to fit more on a cf!)
It was quite a bit of work, without spicy's config inspector, it would of taken much longer to solve.
I also figured out how to use PS1 controllers and memory cards , but did not get around to testing it / don't know the supported games (i think blood roar and aerofighters does something with the memory card?)
My focus was always more on the ZN motherboard , not so much GNET specifically.... I could see the job was a lot of steps, it was much easier for me to use romboard hardware with none of the CF / streaming stuff

... Your work was much ahead of the time, i think people were more jealous than angry.
I'll leave you guys to wrestle the GNET , but i'm here if you need anything testing specifically on the 8mb ram board
Left card works, right card does not
None of my 8gb or above worked on last test.
Primal Rage 2 - my project from MODBIOS 2011 will be done at the end of all ports. you would then all need to install 8MiB RAM . This 2GiB Beast of a game
@Hammy will be the service point for users which do not want to solder . to not ruin my GNET on a bad day i do these ports now quickly
The ram upgrade is easy, due to the fresh pads, the hard bit is moving the resistors / adding the caps without dropping them

PR2 i would say is very high priority, but if you want to do konami's "sacred fist" first, i'm not gonna complain (it's a small game)
