Me and a friend are doing this….
In proto stage currently since i don't have the exact measurements of the japanise spinner, so this could not be 100% correct….
But the topper is just Amazing also this way….
Maybe it will be reduced a little since i think it's too big (5,8cm) and the holes need to be more deep (currently 2mm).
It would be great to have the exact measurements from a real one…..this way the repro will be exactly the same.
I think that 5,6cm of diameter and 4mm of hole deep should be ok and more similar to the real jap one.
It will be used on a modified Taito spinner….
We'll start doing this topper in some times, and some will be available if there is some interest about.
Maybe we should be able to also have available a complete repro spinner including this top board too….
An already working complete repro spinner….maybe..
…
Work proceed....
Here is some update
Here you can see the pushing mechanism.
In proto stage currently since i don't have the exact measurements of the japanise spinner, so this could not be 100% correct….
But the topper is just Amazing also this way….
Maybe it will be reduced a little since i think it's too big (5,8cm) and the holes need to be more deep (currently 2mm).
It would be great to have the exact measurements from a real one…..this way the repro will be exactly the same.
I think that 5,6cm of diameter and 4mm of hole deep should be ok and more similar to the real jap one.
It will be used on a modified Taito spinner….
We'll start doing this topper in some times, and some will be available if there is some interest about.
Maybe we should be able to also have available a complete repro spinner including this top board too….
An already working complete repro spinner….maybe..
…
Work proceed....
Here is some update
Here you can see the pushing mechanism.
Last edited: