Hey all. So, I finally had some time recently to play with the board I was able to get the sprites to show, but as you can see there are still some vertical lines that show up. FYI I did have a perfect picture briefly without the shells attached until I detached the A and B board to put everything back into their shells. I also noticed that depending on how I sandwich the A and B board the DL-2027 chip would intermittently get hot to the point that the screen would turn into garbled video and I would have to turn the machine off to let it cool down. One time I had the machine on without sprites showing and when I pressed hard on one side of the connector pins the sprites came on. I am convinced it's either that the chip is faulty or there's still a contact issue?