jbrlll
Enthusiast
Cps2 hdmi
- Thread starter jbrlll
- Start date
mathewbeall
Champion
Looks clean! That is a hell of a Coax Cable... 
jbrlll
Enthusiast
Lol. It’s a digital coax that I would not recommend for anyone. Soldering the chip side was a beast. It’s all I had and the one thing I will change next time. If anyone has a recommendation I’d appreciate it. I figure with that much shielding I could prob route it anywhere, but does anyone know a better route? I don’t like crossing the top of that Q1 chip. I’ll prob just test with this coax until I order less guage. Thanks guys. Be brutal I have no feelings.Looks clean! That is a hell of a Coax Cable...
mathewbeall
Champion
This is the cable that i used, specifically for the CPS2 install - and it was fine.
https://www.amazon.com/gp/product/B07T28P3MH/ref=ppx_yo_dt_b_search_asin_title?ie=UTF8&psc=1
https://www.amazon.com/gp/product/B07T28P3MH/ref=ppx_yo_dt_b_search_asin_title?ie=UTF8&psc=1
jbrlll
Enthusiast
mathewbeall
Champion
That is a great feeling! Great job.
mathewbeall
Champion
I wish I was as lucky - LOL. I have my NeoGeo apart right now - and when I get a couple of hours this week will be doing the install of this board on it. I hope it boots up first time also!
My CPS1/2/3 installs of this all were met with various challenges that I had to overcome.
My CPS1/2/3 installs of this all were met with various challenges that I had to overcome.
jbrlll
Enthusiast
@mathewbeall, that coax I used is a rg-6 75ohm digital conductor. I realize now the rg-174 is 50ohm, the official documentation wants 50ohm. My video signal and audio signal (7.1 via menu setting and my denon receiver is recognizing a 7.1 input) are incredible. I see rg-58 is more guage than rg-174 but still 50ohm. Am I screwing the signal up with a 75ohm conductor?
mathewbeall
Champion
Well - I would say if its all working - probably not.... That is from a layman's perspective!
Matt
Matt