cps3 DigiAV HS/VS connection points?

[jbrlll]

I'm installing a cps3 digiAV and i have a later model board with the LS08 integrated not a breakout board like in the github with the IN1/IN2 pads for HS/VS.
Marqs mentions the integrated version but I don't see where the HS/VS should connect on my board. My board is a 95682A-3, any advice much appreciated.

 

[jbrlll]

This is my LS08 and from the GitHub picture it looked like IN1 was traced to the pin I have the lower blue wire soldered to (HS) and IN2 was traced to the upper blue wire I have soldered to (VS). But that’s me zooming in on the pic and trying to follow traces I can’t quite see. With this wiring I’m getting a total black screen but my OSD works perfect and is crystal clear. Jamma audio and video are perfect.

 

[jbrlll]

Post in thread 'CPS2 Digitial AV kit for CPS-III'

Oct 29, 2024

Hey guys just wanted to answer some questions that I have been getting.

You will need to purchase a coaxial cable. The one I used is from here:

https://a.co/d/iqLemEg

You will also need some 30 gauge wire for one of the clock signal (C2). I used enabled 30 gauge enameled wire but this one might work as well:

https://a.co/d/fxfeczm

I also used some kapton tape for insulating and some 3m adhesive to stick things together.

kapton:
https://a.co/d/0mRAUwp

wire:
https://a.co/d/6dzmjuA

You also need to get the VS and HS signals off the bottom of the board. The...

• djanice1980

• 

Loop closed, found it here.

 

[jbrlll]

 

[jbrlll]

I just did a full console5 cap kit and reflowed everything the day before I put the digiAV in. Ran coax on both c1 and c2, v1.3 qsb…the colors couldn’t pop more with sharper pixels.