I just got the Lions3 F3 Multi plates.
I have his MV1C MVS plates and 2 of his CPS-1 plates.
I'm a huge fan of his work.
That being said, I had some trouble getting this thing setup.
I think MOST of the issue was MINE.
The first issue I had was with the LCD housing. I couldn't get the back cover installed after with LCD was in the place.
I just ran the screws through the pcb without the back cover installed. It seemed to work out OK.
The next issue I had was that I couldn't figure out how this thing was supposed to be assembled.
I looked at as many pictures as I could find, but they didn't show me what I needed to know.
I ended up doing this:
As you can see, the F3 Multi PCB is all the way on the bottom.
I thought I had to do this because there is no matching slot for the LCD cable in the top plate.
I spent A LOT of time considering alternatives, but after 3 hours I decided this was the way I was going to go.
Please let me know if it's supposed to be setup a different way.
This is the overall look:
*** UPDATE 6/20/21 ***
I think I understand how it's supposed to be setup now.
What threw me off was:
- The slot for the LCD cable being in 1 plate but not the other
- The top of the clips not sitting even with the plates
Side:
Complete:
Clips:
I happy with how it came out.