Error Wit CPS2 Kit (Graphics error, Sounds it's good)

[nikemachu]

Hi have a problem with a CPS2 Kit, it's my second kit. The revision of the board is 6 and the version is PAL G. This is my error:
Video 1 and 2 within audio:
Video 1
[media]https://www.youtube.com/watch?v=9uzCIJq_JTg[media]

Video 2

With spanish comments.jajaja

Video 3

Video 4
https://www.youtube.com/watch?v=i1MOdsM9KbE&feature=youtu.be


Sorry, but the language is spanish!! I test with tester the differentes chips(13 to 20) Upper board and down board, with good test.

Any idea?

Thank you so much!

 

[Mitsurugi-w]

This is your second kit? I assume you tried this kit on your verified working B-board?

 

[nikemachu]

Yes, It's a MArs matrix PAl G phoenix board with new eeproms and no battery. Then I look the good function, I dolder the cable pin 9 to pin 13, and I install the boards

 

[Mitsurugi-w]

Yes, It's a MArs matrix PAl G phoenix board with new eeproms and no battery. Then I look the good function, I dolder the cable pin 9 to pin 13, and I install the boards

Try connecting the wire directly from Pal pin 9 to J17 on the multikit. Though if you are using a Rev. 6 pcb then you should not need a jumper wire at all as long as you have a G pal. In fact, just try removing the wire altogether and push all pins of the PAL into the socket as normal.

 

[nikemachu]

I connected win Pin 9 to Pin 13. I with no Pin 9 to pin 13. The result? The same!

 

[Mitsurugi-w]

Can you test this kit on your other b-board that has the working kit now?

 

[Mitsurugi-w]

Did you get this working?

 

[Malenko]

are the A&B boards connected tightly?