What's new

EZ-Swap PCB Holder Set

This how I have it installed:
1771458786187.jpeg
1771458842532.jpeg
 
Wait, are you talking about movement when you connect a JAMMA harness? The way I read it you were getting movement when you tried to install the board on the holder. Then, yes, there will be some horizontal movement. The goal was to allow different sized boards, if you set up your feet as you've done, you are limited to boards that size. It's certainly possible to put a second sideways slider in there, if that's something you'd want to do.

But making the top slider more aggressive with its grip might damage the boards, so I don't really see a way to do that.

Also, the rails look low to me, if you get any larger PCBs you won't be able to mount them without re-installing them in a higher position. Just FYI. ^__^
 
Makes total sense, there would be a horizontal movement as this being a universal board holder. Thats why I am suggesting if having some stoppers might give extra peace of mind and avoid accidental slide (in x-axis). Also you are right I need to lower those bottom supports and also straighten them a bit :)
 
There is probably a better solution. If I pull them out, I'll probably run a very thin bead of black hot glue into the channel to achieve a better result. Hell, some of those tiny rubber bands probably be enough.

That said, these are still the best solution for mounting a PCB in any cab in my view.
 
Did the STL files get released for these?

Happy to donate some coin for your efforts but I have a 3D printer sat idle I can use.
 
You must log in or register to reply here.
Back
Top