oneleaf86
Grand Master
Yes that's correct.
Good quality Jamma extension cables ?
- Thread starter archimage
- Start date
The Spaniard
Professional
Should the Jamma finger be bevelled? I imagine no but double checking as I'm being asked if it should be and bevelled to 30 degrees max supported.
oneleaf86
Grand Master
Definitely yes!
A beveled edge lets the pins of the edge connector slide over the finger easier and with less force.
30 degrees is perfectly fine too.
A beveled edge lets the pins of the edge connector slide over the finger easier and with less force.
30 degrees is perfectly fine too.
The Spaniard
Professional
Ahah luckily I asked 
The Spaniard
Professional
Im full of these
Does the ATX header have to be a 20 + 4 Pin or can it be just a single 24P piece?
Does the ATX header have to be a 20 + 4 Pin or can it be just a single 24P piece?
oneleaf86
Grand Master
The header has to be 24 pin but the cable can be 20+4. As long as all 24 pins are connected.
The Spaniard
Professional
Ok great, wouldnt a 24 pin be better?
I am looking for a different ATX cable seller. The one linked previously does not seem like a good seller to be dealing with from my experiences so far.
For the ATX cable is all the wiring just standard ATX with just one plug reversed/inverted at one end?
So on the ATX connector pin 1 to pin 1 on the other end? Would this not get a twist in it?
Or is it like this?
I am looking for a different ATX cable seller. The one linked previously does not seem like a good seller to be dealing with from my experiences so far.
For the ATX cable is all the wiring just standard ATX with just one plug reversed/inverted at one end?
So on the ATX connector pin 1 to pin 1 on the other end? Would this not get a twist in it?
Or is it like this?
Attachments
Last edited:
20+4 pin or 24 pin doesn't really matter.
The seller that oneleaf linked before is 100% fine, shipped promptly and packed well -- no issues whatsoever from myself and one other who's ordered from them. I highly suggest you go through them because the cables are tried and tested with this device.
The seller that oneleaf linked before is 100% fine, shipped promptly and packed well -- no issues whatsoever from myself and one other who's ordered from them. I highly suggest you go through them because the cables are tried and tested with this device.
PascalP
Legendary
@archimage can you add this info to your start post?
The Spaniard
Professional
If you bought and paid and shipped with no interactions seems that would be a good experience.
Either way I'm just looking to get the cabling sorted and trying to find out the pin order. I think there are nicer cables out there other than these.
Last edited:
done
I prefer buying the IDC cables pre-assembled.
IDC Cables - select 34 Pin 30cm
Right angled 34 Pin IDC connectors - select 34P
Just a few examples.
Right angled 34 Pin IDC connectors - select 34P
Just a few examples.
that1crzywhtguy
Student
Are the gerbers linked above the most current version now? Also, there are suggested parts in the main post for most of this, but what about the jamma edge connector? Is there one folks recommend?
And/Or, is there someone with one built or in production that's going to be selling these?
And/Or, is there someone with one built or in production that's going to be selling these?
Last edited:
Check the "Project Sentinel" forum section for latest Gerber files and details about pre-built units.