House of the dead 3 guns not working

Shiny

Beginner
Joined
May 16, 2026
Messages
5
Reaction score
3
Location
New York
Close the light and point your camera around the screen. You should be able to see your led around the screen. There should be 10 or 12 if i remember correctly.

If they are all there, time to open up the shotgun and make sure everything is clean, connected and working.
 
Close the light and point your camera around the screen. You should be able to see your led around the screen. There should be 10 or 12 if i remember correctly.

If they are all there, time to open up the shotgun and make sure everything is clean, connected and working.
Cant close the light in a storage unit facility but i have checked the led lights all of them are on going to check the guns later today i also wanna see if people are familiar with the cabinet
 
what is the condition of the gunhoses/harnesses a lot of times they'll get frayed from use or pull out the back side of the connector, or get an internal break that causes weird behaviour.

also what is the condition of the tinted plastic housing over the sensor in the gun? they can get scuffed or scratched and cause poor behavior.

unless you have an LED die or there is physical damage to the LED module or tinted cover it's very rare that there'd be a problem with the LED modules. 99% of the problems with guns in these setups is the sensor in the gun or the harnessing between that sensor and the cab.

HOTD3 is the first game that used the Gun protect board. between the gun sense board and the gun sensors. this was added because so often the harnessing going to the guns would break and short out and kill the sensor, and the protect board protects against that... but it wont fix harnessing issues.
 
Back
Top