Hi,
I received my multi kit from saveyourgames your games last week and installed it onto my Marvel vs Capcom board which is rev 5 and G Pal. I followed all the steps in the instructions; remove mask roms and eproms, I removed the battery from the board, tested the continuity of the jumper configuration, installed the mod, formatted my micro sd card to FAT32, copied the latest base rollup pack onto the micro sd, soldered the key writing wires and plugged it in, finally hooked it up to my arcade machine and I can select the games on the LED screen, it writes the key but all I'm left with is a black screen.
Did I miss a step? Any ideas what I need to fix?
Here are some photos of the setup: https://imgur.com/gallery/g2RYc5m
Thanks
I received my multi kit from saveyourgames your games last week and installed it onto my Marvel vs Capcom board which is rev 5 and G Pal. I followed all the steps in the instructions; remove mask roms and eproms, I removed the battery from the board, tested the continuity of the jumper configuration, installed the mod, formatted my micro sd card to FAT32, copied the latest base rollup pack onto the micro sd, soldered the key writing wires and plugged it in, finally hooked it up to my arcade machine and I can select the games on the LED screen, it writes the key but all I'm left with is a black screen.
Did I miss a step? Any ideas what I need to fix?
Here are some photos of the setup: https://imgur.com/gallery/g2RYc5m
Thanks