Violator80
Beginner
I am in need of some help. A few weeks back I installed the wires to be able to play encrypted roms. I'm a beginner at soldering, but I managed to get everything in place and I was able to boot and play encrypted roms fine. About a week later I started getting 1010 emulator errors while playing. Another forum member told me to reseat my A & B boards so I did that, but then today I started getting scrambled graphics. I tried a few different A boards, but I was always getting scrambled graphics no matter what I did. I decided to go back and look at my solder points and I attempted to clean them up. I was thinking maybe they were the problem. Well, I should have let them alone or gotten some help from someone better at soldering because I pulled up the SWCLK pad entirely. The pad is still attached to the wire as can be seen in the pictures.
What makes this even more problematic is I don't even know if these wires were what was causing the scrambled graphics in the first place.
Is there anyone here that can help me?
What makes this even more problematic is I don't even know if these wires were what was causing the scrambled graphics in the first place.
Is there anyone here that can help me?