Dreamstate
Enthusiast
So, I am trying to get the voltage just right on my ST-V Multi with LCD. The board seems to work great without the LCD, but wants to lockup randomly in games when I do use it. I think the added draw of power from the LCD is causing the issue. Now, on to the real question. If I remove the Board from the Jamma connector, I get around 5.2V. When the board is plugged in, I get exactly 5V. At first I lowered the Jamma only power down to 5ish thinking I was sending too much power, but the board would barely boot before locking up. Where it is now, it runs for 5-10 minutes before locking up. I want to increase the Voltage a bit more, but I want to make sure I am supposed to be measuring when the board is attached and not when there is no load. Advice?