MS8-26SG Slight bowing/convergence issue

[MudGuts83]

Hi all,

I've got a recapped ms8-26SG chassis.

The monitor is vertically oriented at the moment. The top has a slight bowing downwards. The bottom has an off center bowing as well.

Are there any pots on the chassis that would reduce the bowing (i don't have an 26SG specific manual.... and haven't found one, yet)?

I suspect the further adjustments will require convergence strips.

Any help is appreciated!

 

[Mukuro_W]

Most likely you should reseat the yoke.

 

[MudGuts83]

Thanks for the response. I will consider that after pulling the chassis (and purchasing convergence strips and yoke magnets.