What's new
By:

MS9-29 Remote board cable connector

West

West

Grand Master
Joined
Jul 24, 2015
Messages
764
Reaction score
1,172
Location
Brooklyn, NY
Hey AP monitor gurus,

I've been trying to find the connector that works with the MS9-29 remote board.

Nanao MS9.png


Scoured the usual sources, AO wiki, and here, but can't find that part identified anywhere. I imagine it's a JST connector of some kind but does anyone know what it is? And even better, a digikey or mouser part number?

Thanks for any info.
 
Last edited:
On one end it's JST PH and on the other end it's JST EH (both 12 pin). The one circled in red is JST EH, the one that connects to the chassis is PH

Remote board - https://www.digikey.com/en/products/detail/jst-sales-america-inc/EHR-12/527234
Chassis - https://www.newark.com/jst-japan-so...-12/wire-board-connector-socket-12/dp/26H1947

Looks like most places are sold out of EHR-12, which is what you need for the remote board. PM me and I can send you one and the contacts, or make an entire new remote board cable if you need one.
 
Last edited:
@dos You rock man! Thank you. Good info for anyone wanting to make a remote board cable.

PM incoming.
 
Last edited:
West said:
@kikaso I'd hit up the guy at Pxlmod (https://pxlmod.com/products/nanao-ms9-29-arcade-crt-remote-board).

I had a few questions about the remote board and he was very helpful.

Just curious but if you're simply making a harness, why do you need the pinouts? You have the connectors so it's just A to B, or am I not considering something?
Click to expand...
I did some research and it seems that the harness is sequential, I was worried some crossed over.

I’m pretty sure pin 1 on the remote board connector goes to pin 12 on the chassis connector, pin 2 goes to pin 11, etc.
 
You must log in or register to reply here.
Back
Top