andydex
Beginner
Hello everyone,
I have acquired a MV1ACH (I'm assuming Chinese variant) but it didn't come with a slot board.
I have an MV1FZ that is still faulty so I thought I would use the slot board from that as the dimensions are the same but on the MV1ACH but the 100 pin black connectors are actually slightly different.
Does anyone know if doing a connector swap is possible i.e. do these connectors exist outside of the MVS?
Attached is image of the connector on the MV1ACH.
I have acquired a MV1ACH (I'm assuming Chinese variant) but it didn't come with a slot board.
I have an MV1FZ that is still faulty so I thought I would use the slot board from that as the dimensions are the same but on the MV1ACH but the 100 pin black connectors are actually slightly different.
Does anyone know if doing a connector swap is possible i.e. do these connectors exist outside of the MVS?
Attached is image of the connector on the MV1ACH.
