I am replacing a dead raspberry pi in my netbook setup and want to go the route of powering the pi from the filter board. However I do not know what type of connector to use to connect it to the cn12 port. Does anyone know what type of part this connector is, and if so where I can get it?
Naomi CN12 5v connector for raspberry pi?
- Thread starter Evan
- Start date
JST NH
https://www.digikey.com/en/products/detail/jst-sales-america-inc/H4P-SHF-AA/691799
https://www.digikey.com/en/products/detail/jst-sales-america-inc/SHF-001T-0-8BS/527351
seems like they're out of stock though. JST connectors can be difficult to source especially in small quantities.
https://www.digikey.com/en/products/detail/jst-sales-america-inc/H4P-SHF-AA/691799
https://www.digikey.com/en/products/detail/jst-sales-america-inc/SHF-001T-0-8BS/527351
seems like they're out of stock though. JST connectors can be difficult to source especially in small quantities.
J
jassin000
I just used the floppy/FDD power connector off a old AT-PC PSU (fits perfectly just no latching). 
JST parts are retarded expensive now and hard to find.
JST parts are retarded expensive now and hard to find.
kikaso
Enlightened