Pinout video Warrior Blade

[Jmarc]

Hi,

I recently bought a "Warrior Blade" Taito pcb. When I connect it only to the JAMMA connector, I get no picture. Apparently, the video signal for both screens comes out of the white connector next to the JAMMA connector. Does anyone have a pinout of this connector so I can wire a video output, or better yet, does anyone sell a ready-made adapter ?

Regards.

 

[olisan]

Same PCB than Sagaia
Arcade manual available here

https://www.arcade-museum.com/manuals-videogames/S/Sagaia.pdf

 

[Jmarc]

Same PCB than Sagaia
Arcade manual available here

https://www.arcade-museum.com/manuals-videogames/S/Sagaia.pdf

Thank you very much !!!
One last question : do you know if there are any pre-made video adapters for this game that I could buy ? If not, I'll make it myself. Thanks again.

 

[olisan]

No specific pre-made adapter available

Also, game is running only if both screen connectors are plugged i think

 

[Jmarc]

Ok, thanks