mathewbeall
Champion
Hi Folks - I am having what seems to be a similar issue.
I just got my CPS2 Multikit today - very excited! I have a Japanese Xmen Vs. Street Fighter that I have set aside to use. It is a rev 7 board, and I ordered a GPAL chip, just to make sure since what was installed in my board was weird.
The board also didn't have a battery - so it's already been suicided.
I drop the GPAL chip in, and test again with the original ROMS before taking them out - no problem.
I take all the ROMS out and then install the multikit - and while the multikit seems to work and flash fine (from what I can tell from the screen), nothing actually happens on the monitor... it stays black/grey the entire time.
I saw that some folks had to short exc5 - which I tried, but that didn't seem to do anything either.
Next steps?!
Thanks,
Matt
I just got my CPS2 Multikit today - very excited! I have a Japanese Xmen Vs. Street Fighter that I have set aside to use. It is a rev 7 board, and I ordered a GPAL chip, just to make sure since what was installed in my board was weird.
The board also didn't have a battery - so it's already been suicided.
I drop the GPAL chip in, and test again with the original ROMS before taking them out - no problem.
I take all the ROMS out and then install the multikit - and while the multikit seems to work and flash fine (from what I can tell from the screen), nothing actually happens on the monitor... it stays black/grey the entire time.
I saw that some folks had to short exc5 - which I tried, but that didn't seem to do anything either.
Next steps?!
Thanks,
Matt