Replaced CR2032 battery - not booting now - help!

[mathewbeall]

Hi Folks,

I got a LIndbergh yellow multi a few weeks ago, and its been running great. The only one minor thing is that occasionally when booting a CMOS error would pop up, and I would have to hard cycle it again to get it to boot (usually after sitting for a few days). I figured the CR2032 battery was bad, or almost bad - so I replaced it today. Upon first bootup, bot the same CMOS error - defaults are reset, and after that, no issues with that error - BUT , it doesn't boot now... I get this screen below.

Do I have redo something in the CMOS from a settings perspective?

 

[mathewbeall]

I found a post that said that said to make sure "boot lock sequence" in BIOS was set to "disabled" - but if I do that, it just comes up immediately with "no operating system", so changed that back to "enabled". It was a post from a while ago and not even sure if it's the most recent version.

https://www.neo-arcadia.com/forum/viewtopic.php?f=14&t=61702&hilit=Multiboot+crediar

 

[mathewbeall]

I figured it out - I didn't have the JVS cable plugged in....

Matt

 

[Derick2k]

I was going to say check jvs card / connection