Hello all!
I am looking for any information on how one could hookup an RGB SCART modded console (E.g RGB SCART modded Famicom) to an arcade monitor via a JAMMA fingerboard or CGA interface (E.g RGB, GND and CSYNC from monitor on an 8 pin Din to Console SCART)
I have read a lot about Tim Worthingtons SCART to jamma V2 board (Impossible to find) and a few other impossible to find solutions from 2007 forum posts whether it be a Vieltim or Jammaizer. .... Long story short, they got bought up haha
I have also seen on old posts that say "use an lm1881sync stripper on the Csync line and make sure the console is RGB modded or natively using RGB (E.g MD/Genesis) and you'll be golden. Two posts later "it's not a golden standard, each console behaves differently and you will experience flickering/ incompatibility due to power draw issues etc...
I just want to play PC engine or any of my other RGB modded consoles on my Jamma cab instead of my PVM or RGB SCART modded CRT......
So without having to time travel back to 2008 to buy all these adapters (someone beat me to it it seems) how does one simply interface an RGB modded console with a standard arcade Monitor?
I am looking for any information on how one could hookup an RGB SCART modded console (E.g RGB SCART modded Famicom) to an arcade monitor via a JAMMA fingerboard or CGA interface (E.g RGB, GND and CSYNC from monitor on an 8 pin Din to Console SCART)
I have read a lot about Tim Worthingtons SCART to jamma V2 board (Impossible to find) and a few other impossible to find solutions from 2007 forum posts whether it be a Vieltim or Jammaizer. .... Long story short, they got bought up haha
I have also seen on old posts that say "use an lm1881sync stripper on the Csync line and make sure the console is RGB modded or natively using RGB (E.g MD/Genesis) and you'll be golden. Two posts later "it's not a golden standard, each console behaves differently and you will experience flickering/ incompatibility due to power draw issues etc...
I just want to play PC engine or any of my other RGB modded consoles on my Jamma cab instead of my PVM or RGB SCART modded CRT......
So without having to time travel back to 2008 to buy all these adapters (someone beat me to it it seems) how does one simply interface an RGB modded console with a standard arcade Monitor?