NFGx
Grand Master
Thanks to this forum and a photo of a schematic in a manual on an ebay auction, I found all the info I needed to replace the 10-pin adaptor on my Dynamite Baseball panel which I had decades ago sliced the original connector off in pursuit of a doomed controller mod.
Trying to replace this connector was infuriatingly difficult because the actual pinout of what analogue signal went to which controller device was totally unavailable - until I found that auction. No one but me is dumb enough to just cut off the connector, I guess.
I also put up all the panel <-> cabinet pinouts and wiring diagrams on my site, plus some info on making an axis reversal switch for Monkey Ball.
https://gamesx.com/wiki/doku.php?id=arcade:sega_naomi_analogue_panels
Hopefully I'll get around to testing these soon! Where's my f**ken Naomi got to?
Update: All tested and confirmed accurate.
Trying to replace this connector was infuriatingly difficult because the actual pinout of what analogue signal went to which controller device was totally unavailable - until I found that auction. No one but me is dumb enough to just cut off the connector, I guess.
I also put up all the panel <-> cabinet pinouts and wiring diagrams on my site, plus some info on making an axis reversal switch for Monkey Ball.
https://gamesx.com/wiki/doku.php?id=arcade:sega_naomi_analogue_panels
Hopefully I'll get around to testing these soon! Where's my f**ken Naomi got to?
Last edited:
