Tekken Tag / Namco System 12, boot loop watchdog

Greetings mate, I have the same problem, has anyone come up with an advance or a solution?

I'd be very gratefull
PS: I have this same error on a Tekken Tag
 
This solved my issue thanks!!!!
Helloo!
it worked for me as well, thanks!

I reflowed the pins of pretty much all the chips on the daughterboard with no luck, then I read here about pressing the 2 boards together..
So I put a generous amount of IPA on both connectors, reseated the board and pressed them together.. and it booted right away.
And it continued booting after releasing them, not sure for how long it's going to continue booting
but at least I know where to look if that happens again.

Thank you all ;)
 
Hello again, just one last update: today I finally found the time and managed to fix my booting issue (hopefully for good).


After some more tests, pushing the ROM board down to make it work, I realized that while pushing I was also flexing the motherboard. So I tried flexing only the mobo, on the sides of the connector, and noticed that this alone was enough to get it running.
Between the JAMMA edge and the ROM board connector there’s a little chip, which I reflowed, and since then it’s been running just fine.

The chip is a Fujitsu 29F400TA-90 flash (MBM29F400TA-90).
1794992916472.png



I hope this helps anyone with little experience like me who’s repairing these boards.
Cheers!
 
  • Like
Reactions: xga
Back
Top