BladeZX
Champion
I have one of those 2 inch trackballs that have USB or 3 wires on it
Attached is the pinout of the trackball
How would I connect this to the MiniPAC opti board?
The +5 and GND are obvious but the extra 3 wires are labeled M, R and L
I would think I would need 4 wires (X1, X2 and Y1, Y2)
Anyone help?
Attached is the pinout of the trackball
How would I connect this to the MiniPAC opti board?
The +5 and GND are obvious but the extra 3 wires are labeled M, R and L
I would think I would need 4 wires (X1, X2 and Y1, Y2)
Anyone help?
