Robertguy09
Grand Master
I recently setup my hursit mini cute repro. I have a WG k7000 chassis with a compatible 19in tube/yoke from a consumer tv.
I am not sure if the degauss is working on start up. I have some very minor discoloration that I would typically think the start up degauss would take care of.
So far I checked that the degauss coil has continuity (it does). Then I tired to measure some voltage from the degauss pins, but I'm not sure what range to expect. Here is a video:
https://photos.app.goo.gl/E4xbjqkNpFuh9gfK8
Can I get some advice on what/how I should check the degauss circuit is working?
Thanks!
(I do have a degauss wand I can use)
I am not sure if the degauss is working on start up. I have some very minor discoloration that I would typically think the start up degauss would take care of.
So far I checked that the degauss coil has continuity (it does). Then I tired to measure some voltage from the degauss pins, but I'm not sure what range to expect. Here is a video:
https://photos.app.goo.gl/E4xbjqkNpFuh9gfK8
Can I get some advice on what/how I should check the degauss circuit is working?
Thanks!
(I do have a degauss wand I can use)