The below looks like it's syncing just fine.
Instead I got the following info on the mini display:
AV3_RGBS 263-p
15.62kHz 59.41Hz
Instead I got the following info on the mini display:
AV3_RGBS 263-p
15.62kHz 59.41Hz
My bad, I missed the double negative in the op.The below looks like it's syncing just fine.
Nice. In full HD too?OSSC works great with a Datapath E1S. Have captured MVS many times with that combo.
Thank you for running all the tests.... Unfortunatley the board I have is a MV1FZ... So I guess I'm fucked here...? ANyone got a MV1FZ board working with the splitfire?I just tested some of my MVS boards with my OSSC. It's a v1.6 board with v0.88a firmware. I don't have a splitfire. I used a Jammafier 2.0 in JAMMA mode, which means the signal should be untouched from the game and passed straight through to the VGA connector. I also tested in Tri-sync mode, which afaik is similar to the Splitfire in that it buffers the sync and is intended for 75ohm inputs.
Jamma mode
My MV1FS, 2x MV1B, and MV1C boards all worked without manual profiles. The video was wiggly though and colors are washed out.
My MV1FZ did not work. It works fine on my CRT JVS cabinets.
Tri-sync mode
Only the MV1B and MV1C worked. The image was better than in Jamma mode too.
MV1FS got sync but had no picture. The MV1FZ got no sync.
Did you try these settings for the MV1FZ?:The MV1FZ got no sync.
Those settings didn't help with the raw sync signal from the FZ. BUT, they did work with the JVS + Regen C mode enabled on the Jammafier.Did you try these settings for the MV1FZ?:
Sync OPT. -> H-PLL Post-Coast - 2 lines
Sync OPT. -> Hsync Tolerance - 8.30us
On AV3_RGBS.
It's still worth trying. It depends on your board.Thank you for running all the tests.... Unfortunatley the board I have is a MV1FZ... So I guess I'm fucked here...? ANyone got a MV1FZ board working with the splitfire?
I know I'm picky. I just upgraded my gear for Youtube captures to 4K, so that's a no go for me.I usually just use line2x. Looks good enough for me.
Yes, at least I got sync with those settings, so I'll keep on trying. Gonna try with two different capture cards in a few days.It's still worth trying. It depends on your board.
Yes, at least I got sync with those settings, so I'll keep on trying. Gonna try with two different capture cards in a few days.
Thanks! might be worth a go if everything else fails..I keep a couple Dr HDMI's around for when I encounter handshake issues. Might be worth a try if you can find one cheap.
Example: https://www.ebay.com/itm/166599222237