I have been having issues with my CPS2 install.
Mainly, a red screen on boot with all roms except Progear which has garbled graphics.
Started the diagnosis process with the simplest first and messed (on my third which is recommended by another sucessful player on these forums) around with the SD card. Same results as above.
I then moved on to uninstalling the kit and re-seating everything. Same results as above.
Currently, I am testing the jumpers and have found two (J10 and J12) that should be open (and by all appearances are), however, the multi-meter reports them as shorted. I have tried everything I can think of short of maybe cutting the traces between the pads to get these jumpers open. I am using a solder sucker to try and clean things up and am wondering if maybe that tool is not precise enough for the smaller amounts of solder possibly left behind? Today I cleaned the area with alcohol to try and clean any flux that might be creating havoc and still no results.
Does anyone have any insight?
Mainly, a red screen on boot with all roms except Progear which has garbled graphics.
Started the diagnosis process with the simplest first and messed (on my third which is recommended by another sucessful player on these forums) around with the SD card. Same results as above.
I then moved on to uninstalling the kit and re-seating everything. Same results as above.
Currently, I am testing the jumpers and have found two (J10 and J12) that should be open (and by all appearances are), however, the multi-meter reports them as shorted. I have tried everything I can think of short of maybe cutting the traces between the pads to get these jumpers open. I am using a solder sucker to try and clean things up and am wondering if maybe that tool is not precise enough for the smaller amounts of solder possibly left behind? Today I cleaned the area with alcohol to try and clean any flux that might be creating havoc and still no results.
Does anyone have any insight?