Raph_friend
Grand Master
It's just normal printing from a Brazilian factory my friend!Those 3D printed shells are next-level beautiful! Is it resin? How do you get them looking so good?
IC1 | S-816A40AMC-BAPT2U | SOT-23-5 | Linear Regulator Positive 5V 1A 5-Pin SOT-23 T/R - Tape and Reel |
Answered on discord.hi,
I would like to try to realize my USB2DB15.
I can't found easyly
IC1 S-816A40AMC-BAPT2U SOT-23-5 Linear Regulator Positive 5V 1A 5-Pin SOT-23 T/R - Tape and Reel
do you think I can use:
€ 0,78 Réduction de 6% | Lot de 20 pièces LM321 LM321MFX A63A sot-23-5
https://a.aliexpress.com/_vWUMgf
or do you have link?
Regards
Can you please tell the errors?Does anyone have the parts list or a Digikey cart for this project? Seems the there might be some formatting errors with the CSV file retrieved from GitHub.
Since it is saved as a CSV file, the line for C2, C3, C4 is displayed incorrectly. I am correcting it now.Can you please tell the errors?
1. It looks good. We only care about the position of the holes on the PCB because everyone (or 99%) who uses superguns is aware of the female/male sides. But it's a good point, and I'll add it to the BOM.Since it is saved as a CSV file, the line for C2, C3, C4 is displayed incorrectly. I am correcting it now.
I am also finding discrepancies for these parts:
- DB15OUT
- You have it listed as "DB15M/90"
- But since this is going to mate with a SuperGun, which has a male DB15 plug, I feel this should be "DB15F/90"
- Please confirm if this part number works for this component
- LED
- Please confirm if this part number works for this component
- C1
- Please confirm if this part works for this component
- C2-C3-C4
- Please confirm if this part works for these components
- R2
- Please confirm if this part works for this component
- R3
- Please confirm if this part works for this component
Just to be sure, which LED is to be used here:2. Looks fine.
Common (diffused) cathode.Just to be sure, which LED is to be used here:
- Common anode?
- or
- Common cathode?
@Raph_friend, can you please post the gerber file? When I convert the *.brd file in EasyEDA, the silkscreen is lost and for some reason I can't reset my Eagle password.