That looks nice man! I like the green voltmeter, something different.
Switches are fine, they function the same so who cares which spot they're in lol.
I think things will settle down soon re revisions. Not much else to improve upon / change. When things are fully finalised I plan to add a separate revision with a Mega Drive II DIN.
Early next week the updated 4P adapters will land so I'll get that updated. The only other things I'm looking at refining are:
Voltmeter pins (bit tight fitting the wires in there)
Mounting holes (too close to edge / other components perhaps - maybe some tabs on the PCB edge are needed)
TTL sync output (for Taito F3 and video conversions)
When it's more finalised then we can look into case options, 3D printed or plexi etc.
Switches are fine, they function the same so who cares which spot they're in lol.
I think things will settle down soon re revisions. Not much else to improve upon / change. When things are fully finalised I plan to add a separate revision with a Mega Drive II DIN.
Early next week the updated 4P adapters will land so I'll get that updated. The only other things I'm looking at refining are:
Voltmeter pins (bit tight fitting the wires in there)
Mounting holes (too close to edge / other components perhaps - maybe some tabs on the PCB edge are needed)
TTL sync output (for Taito F3 and video conversions)
When it's more finalised then we can look into case options, 3D printed or plexi etc.