Recent content by AaronNM1

check where the video signal plugs into the chassis. i had a similar issue on a monitor, and it was cold solder joint on the rgb connector.

Pulled from an mk2 that i picked up. Had Mk2 and UMK3 working on the switcher. that is all i tested before pulling it. appears to be the same set that is sold here: https://riddledtv.com/arcade/kits.html#MK_Kit 140 shipped hit me up with any questions you have.

sold, thanks!

sold pending payment. thanks everyone.

60 100yen coins. 70$ shipped paypal F&F. Message me for more info.

Looking to sell some used WACCA LEDs. All were working when pulled. Want to offload them before I stick them in a closet and forget about them. 60 Available. Willing to sell you any amount you require. If you have a few burnt out, but don't want to replace the whole set, these might match your...

Looking forward to it.

@Cereth, Did you decide to keep the bombergirl? i was looking forward to a video on that one.

Wanted to jump in ans post positive feedback for Cereth. Wacca cab came nicely packed, and in great condition. Second cab purchased, and hope to buy from again. Low stress transaction.

FOUND

Game is sold. Thanks!

More pics

Authentic Metal Slug 5 with shockbox for sale or trade . Little tear on label, but otherwise a nice clean cartridge. Looking for Money Puzzle exchanger or a Demon Front Cart in trade. Might be interested in equivalent value mvs cart, Let me know what you have. 320 shipped in US. DM for more...

The voltage will change once a board is connected. Then adjust it to 5v

@AMS do you know where I would look in the manual? https://drive.google.com/drive/folders/1TSnuYMWuUeKxX512BUmKBiIKov6fBPGI I'm not sure what board controls the lights yet, so I'm not sure what i would be shorting. Thanks in advance, Aaron