Recent content by animesuperj

I have one in mine. Just tie both sync wires together.

How long do we have to order the single player panels? I'd like to get one, just low on money right now for arcade stuff (thanks Christmas presents, lol). Will there be an overlay created for the single version?

Got the parts to repair my monitor in on Saturday, so spent a little time getting that up and running. Finally have the cute up and running! Played a few games, and still horrible at Ghouls 'n Ghosts, lol. It's been a while since I played the arcade version, so time to brush up on this one...

No static, ac is going through the iso. Rgb, ground and sync should all be hooked up correct. I'm using a g07, so tied the sync together as well. Assuming at this point I might have bumped something when removing the monitor and chassis out of the original frame and putting into the cute. Just...

Yeah, that was it. I thought I had done that prior during building, so I didn't even double check. Derp. Thanks for the tip! Board powered up, but now not getting anything on the monitor. Just need to figure that out and should be good. Just to double check, black on monitor connections goes...

The switching psu that came with the kit with buttons. I have ac voltage in, but no +5, +12, etc. I tried it with my working board plugged in, also nothing.

Tried powering mine up, I'm getting 120 to the switcher, but no dc voltage back out. Any suggestions? Everything I've checked seems fine, wondering if it's a dead switcher?

This was my experience, and a couple suggestions. Take it with a grain of salt. I did the hinge method as it's familiar with me on how I've done other art for games. After finishing, I'd say this was one of the more difficult pieces I've done, or at least needing to REALLY pay attention to what...

1 for me

That's what I assumed, just wanted to double check.

Just an FYI on the wiring harness pdf, the colors for the P2 connections don't match. It looks like they were copied from P1 (brown/red/green) and not re-colored to the P2 colors, which should be green/blue/violet.

Question on button sizes - what size are used for: player buttons, P1/P2 start and service?

Mine arrived Saturday morning. Unpacked and laid everything out. Thankfully the kids went to a friend's house most of the day Sunday, so was able to knock out assembly. Can't wait to get the last remaining pieces in (monitor, iso and iso harness) and have this up and running! Planning on putting...

As someone who's seen / dealt with him in the classic arcade and pinball communities -- your observations are spot on.

Thanks for the work! My cab should be here in the next day or two, so excited to start building this thing. I'm in for the ISO harness, let me know when / where to send payment! Also, I might have missed this or don't remember - is the ISO transformer itself included or do we pick that up separate?