Recent content by freddiefiasco

Hi @chunksin, is this a good BOM to sticky somehow for those following your progress? Are you still looking for a copy of ID7?

Yes I still do.

I have a Street Fighter Zback HS5 cab with a 25” RCA A63ADT10X05 CRT. I added a T8 LED bulb to the marquee to complete the cab, however, when the CRT is plugged in at the same time as the Marquee, the marquee doesn't power up. When I unplug the CRT, the marquee bulb works. I noticed that both...

Thanks, I have one of these too but I think it will have to do for now. Thank you for the confirmation.

Is it possible to use a JVS I/O board with Windows 10 for emulation? If so is there a way to pull drivers for use with Windows 10 to communicate directly with JVS and whatever emulator is to be used?

For lindbergh, you can use a standard ATX PC to power the Lindbergh. The Power Supply for the Lindbergh is an external PSU. The RingEdge has an internal PSU, I believe the thresholds are the same as in the US (not sure) where you can plug the RingEdge directly to the power source. I believe...

Looking to sell a few of my cabs that are in storage. I no longer have room to set these up and would like them to go to someone that will take care of them. ID5 Single Cab: Will come with Lindbergh and ID5. The cab will work with ID4, ID6, ID7, ID8. It can work with ID1-3 with a minor...

1GB. It's the same stick that came with the console.

Unfortunately, I do not. Do you have a recommendation of what alternative I/O I should use to test or should I look for another Rev B to test and confirm? I am reloading another 2.0 image to make sure I did the image properly. I found that when I tested one game, SF4 2012 Patched, the screen...

Thanks all. I was able to figure it out by posting my question on here. I ended up re-wiring my harness and there was a cross connection between my 1P SW1 and 1P SW3. After testing continuity, these two switches ended up being connected. My Multi 1.4 works again. However, I did find that...

Model215A. I'm not sure it's a FastIO card but its the JVS that comes with my console. (Circled in red, this is just a sample image but similar to mine) I think I need to rewire the whole harness to make sure I'm not missing any connections. Should Ground be shared between all switches...

This probably doesn't help much. I will probably have to tear out the JVS and trace the wires properly to get better pictures. Which ground on the JVS I/O should be used for the switches/buttons? It's a little hard to take a pic of the wires as they are inside the cab but here are some images...

I'm using a Sanwa 5 pin joystick. UP: Pin 18 DOWN: Pin 19 LEFT: Pin 20 RIGHT: PIN 21 LP: Pin 22

Try looking for the Hitachi Deskstar 41.1GB Hard drive when you run your installation. I have had luck with Maxtors as well but the Hitachi 41.1GB drive gave the best results.

Not really too familiar with that acronym. I'm hoping my mappings are the culprit. I found it odd that when I was running 1.4, the P1 directional keys worked, popping in the 2.0, now they don't.