Recent content by kratt

Yes, I have 2 multis. And I try replacing the A and C Boards but it doesn't work (sound). PM sent

Hi, it's been 3 months. I copied it after formatting it to FAT32 on a Windows PC. I tried exchanging the MicroSD of another CPS1 Multi that worked correctly, but the troubles did not improve.

I connected the wires according to the installation instructions. Please refer to the photo. A board's PAL has been replaced by darksoft's product. My A board from Street fighter 2 champion edition. The A board ran well, and the sound was perfect. The games tested are Willow, AREA 88, tenchi wo...

The problem that the game we talked about last time didn't work was the c-board's pal. I solved it by replacing the c-board. Now there is no sound. All games have no sound. When I contacted a professional repairer of the ARCADE PCB, they said that there is no signal coming out of the FET and...

Voltage is always checked, and pcb is always checked when reading a file. When I went out and came back to check it, the pcb didn't work. Just a black screen with no 'No signal' indication on the screen. I have two darksoft cps1 loaders. The one with the Q1 chip installed works very well in the...

No, I put the volt meter in jamma slot. Always the voltage is set to 5.0v.

At first, it is playable. But later it becomes impossible to play. In this situation, switching to another game does not improve.

No, I use NNC. another jamma pcb work perfect.

yes. The sound and game programming are good. Only the screen turns off.

I have a problem. Choose a game. And after about 10 minutes of playing, the screen turns off and turns on again after 5-10 seconds. I have an issue where the screen doesn't come out at all while looping. I replaced the A board, but the problem is not solved. The soldering of the wire...

yes

It is available. It requires additional wiring.

Thank you for the reply. When I tried since first, I change only program roms. Maybe senkyu's sound transfer in mobo. re-transfer has been a success. Now is fine! The only problem remaining is the 'NEW VERSION' logo. :)

Thank you for sharing!! Background becomes perfect! but.. sound is imperfect now. same as before.

Nice work! I want to know how to do