Recent content by Rukas

Yep A board crew! The A boards ive found fail less than the B not sure why just my experience. You may not need the stereo card it sounds pretty good in a decent cab already.

Stole this from Candycabclub.com ;;) Thanks DJ B board comes with factory I/O usually as was a later release.

D Does the T7 board have the USB dongle key with it? The hdd inside also may have come loose from the SATA connection.

Congrats on the freebie. I can answer some of these questions for you. 1. From the monitor label can you tell which one it is? - You have SANWA branded LCD imo its the better one. 2. Can someone post pictures of the coin area so I can reconstruct this metal I have for it. - Pics added 3. Can...

go to the menu and set the picture to wide. Either that or take out the cable on that replacment board and plug it back into the back of the old controller near the coin slot

future proof it mate with the 165hz goodness. I wanna copy it when your done getting the backplate dimensions sorted ;)

Hi All, Has anyone seen a cps1 board do this? It has only red and black colour and completly broken sprites. View: https://youtube.com/shorts/wDJChjx3PXU?feature=share

Got any pics of it open so we can see ? :)

The reason those other ICs are stalling there is usually because CPU2 is bad or testing blank. Try the CPU swap before doing the ICs again. I have done a few boards in the last year with the same issue. From memory you can use the sega saturn cpus as they are the same however im not 100% sure.

Hold the service button on boot (gives you a diff service menu) and check the CPUs. If you run the test and one is bad grab a heat gun and reflow the legs of the 2 cpu chips. They have a tendency to bend legs out when you put carts in the board.

Take the front cover off your panel and see if the tube in the top is blow (4 screws each side). This & the control panel lights will power on usually without any namco games etc installed. Ive got a spare c2-is-n amp over here if you get stuck with the speaker solution. There are a bunch on...

One of my netdimms has this same issue. Must be crazy common.

You can Just run a PC off the IEC in the cab no worries. This setup has had mame in it for ages and is setup like a arcade pcb.

The 3rd one down in these looks awesome especially being metallic black for the background

Id be up for a couple for sure