Search results

Great Seller here!

No, It had already suicided and as ekorz mentioned, nothing is really dead these days...

Looking to sell the following items tested working: Hopefully no issue with guidelines in selling the complete CPS2 Multi. CPS2 SOLD - Darksoft CPS2 Multi A+B USA boards - $850 (Small corner crack has been repaired on lower right of B board but barely noticeable) SOLD - Marvel Vs Capcom A+B JP...

Please put me down for 1. Thanks very much.

Looks like it was pinned above LCD troubleshooting / repairs

So I must have popped off the Up Button on the LCD screen somehow, but I can't find it anywhere - the actual lower part is still soldered into the board just fine but any idea what the replacement button is called (or where I might find one)? || Thanks

All patched up and working again. I guess there was too much slack in the cable and as my luck would have it, it landed right over the screw hole on the B board. Live and learn.

Well, found the issue. When I put the shell back together one of the screws went right through the ribbon cable for the LCD. I'll see if I can fix this with some jumper wires. FACK ME

Hey All, So I installed my kit today, including the auto reset wire - everything worked perfect. I played a few games, and then loaded up dimahoo - played for about 30 min or so. Now, I can no longer load any different games. I can move back and forth to any of them, but pressing enter does...

Yeah my rev-3 board doesn't have it sadly. Ok no problem, I will connect it to the com connector pin B21 on CN7. Thanks guys!

Thanks Dark, I should have been more specific, I guess I'm just wondering what pin should i use for the other end (CN7 pin 21/com connector, or CN1 pin 28 - soldered) Picture example I've seen

One question I had around the auto-boot feature From the guide it says In order to have also auto reset feature, you need to solder a cable between the SWD5 “dot” in the CPS2Multi which can be seen below and the pin B28 of CN1 connector in the B Board. But in most of the pics I see people are...

This is really good information, Thank You.

lol well there ya go! I feel incredibly foolish now for missing that, but thank you :^)

Thanks for the suggestions guys. So to summarize, Board will work Pull the daughter board and other roms Find a palG chip Jump pin 9 (lifted) to j17 on the multi pcb. I appreciate the feedback and hope to try this out once available.

Nice, Thank You Mitsu Just a few more questions then, and I believe I'll have this sorted. I'm assuming the daughter board on the REV 3 would just stay in place then? (no removal needed for the multi install) As it's a rev 3 board - I would just run a wire from pin 9 of the PAL G to the J17 on...

Hi all, I'm interested in getting a multi kit once they are available again but I don't know if the board I have is suitable or not. I received this already phoenixed but I'm not sure what game it was originally (it is now a SSF2 X) It looks to be a rev 3 but I do not know what PAL it has (a...

I think U9 and U10 are these http://console5.com/wiki/74273 I found this thread about them http://www.neo-geo.com/forums/showthread.php?179241-Troubleshooting-MVS-2F-video-problems Not sure but they could be between 150 and 220 ohms.

Hi All, I'm Ballzdeepx over on NG. Some of you may know me from over there anyways as I've seen a few familiar faces while lurking. I play a ton of games and have been for over 30 years as I'm sure most of you have as well. Recently I've started playing some PCBs by way of supergun and been...