So I just completed a n RGB mod for the JVC TM-1700 and my chassis slid off a plexiglass table I was stupidly using to support it. Bye-bye tube. 
So this Chassis is now available. It's RGB modded, and looked great before it went kerplunk.
It could be used for different sized Arcade Cab such as a 19" setup with appropriate yoke impedance.
Many tubes use the same socket type, such as Sanwas and K7000's
Available to purchase is either the Chassis alone, or Chassis with shell, bezel, buttons and all screws etc.
I don't know the exact tubes which are a match, so here's the information that I do have:
Original Tube: M41EEM311X360
Socket: CR-31
Socket Model: B10-277 (A lot of Arcade Monitors use this)
Impedance RH 3.6, RV ? (My yoke broke also)
A similar reading could be taken from another JVC TM-1700 or Bausch LTC2917 CCTV.
Would be asking $140 plus shipping.
Shipping for Chassis only will be quite a bit less than with the exterior shell, due to size.
So this Chassis is now available. It's RGB modded, and looked great before it went kerplunk.
It could be used for different sized Arcade Cab such as a 19" setup with appropriate yoke impedance.
Many tubes use the same socket type, such as Sanwas and K7000's
Available to purchase is either the Chassis alone, or Chassis with shell, bezel, buttons and all screws etc.
I don't know the exact tubes which are a match, so here's the information that I do have:
Original Tube: M41EEM311X360
Socket: CR-31
Socket Model: B10-277 (A lot of Arcade Monitors use this)
Impedance RH 3.6, RV ? (My yoke broke also)
A similar reading could be taken from another JVC TM-1700 or Bausch LTC2917 CCTV.
Would be asking $140 plus shipping.
Shipping for Chassis only will be quite a bit less than with the exterior shell, due to size.
Last edited:
