Hello everyone, I have been setting up a Naomi board with the piforce with netdimm for the last few weeks,I encountered visual problems with no video signal.I was able to resolve the issue (thanks to
The system is firing up normally with no issues ,but certain buttons and joysticks are not functioning.
I searched the forum and found a post thread with similar issues, (https://www.arcade-projects.com/thr...aspberry-pi-but-no-visuals.19566/#post-302433))
I used the advice in the above link attempted the following steps:
1. I accessed the test menu, used the reset data option, used the game configuration control test function.The control test registers the Player 1 joystick and buttons 1-6 and the service and test buttons l wired up to buttons
However P1, P2 start buttons Player 2 joystick and the corresponding buttons 1-6 doesnt register.Overall despite test mode registering P1 controls ,there is no response when I load up a game.Only the service and test buttons work while the game is running.
2. I checked the capcom l/O board for any obvious issues(jamma connector not fastened securely,configured to 2 player not 4 player,the board recognizes the I/O board,kick harness secured )
3. I checked with multimeter for continuity with ground wires(there was continuity with P1 controls,test and service buttons,but no continuity with P2 controls and P1 AND P2 start buttons
From what can tell:
1. I did see a suggestion in the aforemention post to change control output from analog to digital(I checked the options in the test menus to change the setting,so far I see no options for ,either its not present or I'm missing something) How do I do that?
2. I should change out the jamma harness to a new one replacing the ground daisy chain and test for continuity before I connect things up in a permanent configuration?
Thanks for any help and attention!
skate323k137 for his help!)
The system is firing up normally with no issues ,but certain buttons and joysticks are not functioning.
I searched the forum and found a post thread with similar issues, (https://www.arcade-projects.com/thr...aspberry-pi-but-no-visuals.19566/#post-302433))
I used the advice in the above link attempted the following steps:
1. I accessed the test menu, used the reset data option, used the game configuration control test function.The control test registers the Player 1 joystick and buttons 1-6 and the service and test buttons l wired up to buttons
However P1, P2 start buttons Player 2 joystick and the corresponding buttons 1-6 doesnt register.Overall despite test mode registering P1 controls ,there is no response when I load up a game.Only the service and test buttons work while the game is running.
2. I checked the capcom l/O board for any obvious issues(jamma connector not fastened securely,configured to 2 player not 4 player,the board recognizes the I/O board,kick harness secured )
3. I checked with multimeter for continuity with ground wires(there was continuity with P1 controls,test and service buttons,but no continuity with P2 controls and P1 AND P2 start buttons
From what can tell:
1. I did see a suggestion in the aforemention post to change control output from analog to digital(I checked the options in the test menus to change the setting,so far I see no options for ,either its not present or I'm missing something) How do I do that?
2. I should change out the jamma harness to a new one replacing the ground daisy chain and test for continuity before I connect things up in a permanent configuration?
Thanks for any help and attention!