Hello
On my NNC (Toshiba/Toshiba combo) I done a very good adjusment. I have 2 chassis with new cap (original and part), and I tried a turn over for run alternatively it. Off course, I had to re adjust with OSD. I used original adjustement some parameters is close (color....) other different, until there it's normal.
But convergence issue it's not same, With original I eliminated the little convergence with strip, but with new the convergence reappeared.
My question: is the convergence issue can depend about the chassis?
Thanks
On my NNC (Toshiba/Toshiba combo) I done a very good adjusment. I have 2 chassis with new cap (original and part), and I tried a turn over for run alternatively it. Off course, I had to re adjust with OSD. I used original adjustement some parameters is close (color....) other different, until there it's normal.
But convergence issue it's not same, With original I eliminated the little convergence with strip, but with new the convergence reappeared.
My question: is the convergence issue can depend about the chassis?
Thanks