Update:
So I bought the universal adapter but it was tricky connecting it to the tube one of the connecters didn't really seem to make contact with one of the pins on the gun. But I found a guy on Klov who makes the adapters and got one from him. This adapter just slid in perfectly.
When I first used the Universal adapter I got a low reading on all 3 colors, I researched online and looked at a few videos on how to correctly test and rejuvenate the tube. I first started off with a clean and balance which is the lowest and safest way to clean your tube. Nothing really changed so I switched it to the rejuvenate option, after I did that It gave me no reading at all in the test mode. I left it alone for a few days and got the new adapter from Klov which correctly fit on the neck.
I wouldn't recommend getting the Universal adapter, first its $80 bucks and second it doesn't slide in, rather its small hooks that hook onto each pin, maybe I must have had it hooked on a wrong pin, not sure. I used a diagram that I found online to see what connected where but maybe I did it wrong.
After receiving my new adapter I did the test again and still got zero reading from the needles. I wasn't sure if my rejuvenator was fucked or if the monitor was just dead. So I decided to test out my Neo29's tube, did the same setup and test and I got good reading on the tube. So that means it must have been on its last legs and I killed the monitor.
I also noticed when I did the test on my neo29 I would get a red glow on the neck and I wasn't even getting that on my NAC tube.
So that sucks, now how do I go by getting a similar tube that will work with my chassis?
The NAC tube I have is a Toshiba 29" A68KJU96X and my chassis is a Nanao MS9.
