I did actually design a PCB to access a PGM card from a micro controller, but so far didn't have time to write all the firmware... I want to try to program it in-circuit as well, with a jumper wire for /we.
- Thread starter juyoujing
- Start date
For Sale
Monstermug
Professional
I found it strange that when inquiring about purchasing demon front I was directed to another site where I was told I can purchase them there:
https://www.aliexpress.com/item/100...m=5261.ProductManageOnline.0.0.7cfa4edf3lb6WA
Then when I requested to see sight of the actual cart I was going to get I received pictures of this.
Maybe the OP can clarify this as this does not instigate very much confidence.
https://www.aliexpress.com/item/100...m=5261.ProductManageOnline.0.0.7cfa4edf3lb6WA
Then when I requested to see sight of the actual cart I was going to get I received pictures of this.
Maybe the OP can clarify this as this does not instigate very much confidence.
Monstermug
Professional
My point is why advertise carts and then send a pcb version... Probabaly an honest mistake but lucky I asked for pictures of exact item i will be getting if purchased. Anyway i'm out. Can't be asked for this nonsense.
ChrisBEANS
Professional
Similar nonsense going on in the sellers thread for AW carts. I'll be steering well clear.
ChrisBEANS
Professional
For what it's worth, there are always Korean DF PCB's on eBay. Always the same seller.
I have one, it's legit, came nice and clean, works perfectly (battery removed too), and it's cheaper than advertised here too.
I have one, it's legit, came nice and clean, works perfectly (battery removed too), and it's cheaper than advertised here too.
