BIG BEAR
Enthusiast
In need of MV1B adapter boards in the USA
- Thread starter BIG BEAR
- Start date
Ape Cosplay
Grand Master
The gerbers for the original design were released here some years ago. Maybe someone grabbed them. Otherwise I'll dig for them if you want to have a few printed.
[EDIT]
From 2019, gerbers in attachment, credits Apocalypse.
[EDIT]
From 2019, gerbers in attachment, credits Apocalypse.
Last edited:
BIG BEAR
Enthusiast
I appreciate your reply.I may have some printed up in the future unless somebody has some spares.
I just needed a pair real quick to complete a repair.
What I did is just ordered the male sockets from AliExpress.
I may report back here and give my opinion on those.
BB
I just needed a pair real quick to complete a repair.
What I did is just ordered the male sockets from AliExpress.
I may report back here and give my opinion on those.
BB
BIG BEAR
Enthusiast
The connecters have arrived!!
They cost approximately 18.00 shipped and about a week and two days to get to me so now what I will do is remove the original connecters from the main PCB once again and install these.
The problem should be resolved and these connecters will ensure a stable connection between mother and daughter board lying flat.
Any daughter board corrosion or not will/should make a solid connection between the two.
I will return after they're replaced.
BB
They cost approximately 18.00 shipped and about a week and two days to get to me so now what I will do is remove the original connecters from the main PCB once again and install these.
The problem should be resolved and these connecters will ensure a stable connection between mother and daughter board lying flat.
Any daughter board corrosion or not will/should make a solid connection between the two.
I will return after they're replaced.
BB
Attachments
BIG BEAR
Enthusiast
Alrighty...done deal and she works perfectly right away.I had to remove the reinforcement pins on the connecters because they will not align properly with the board.
I prefer these over the pcbs only because I went through a great amount of hassle and wasted a lot of time trying to make a solid connection and failed.
This looks good and no worrying about corrosion and or cold solder joints.
BB
I prefer these over the pcbs only because I went through a great amount of hassle and wasted a lot of time trying to make a solid connection and failed.
This looks good and no worrying about corrosion and or cold solder joints.
BB
