Lost red after recap ms2930

[Williamcritchfield]

Lost red after recap. Any idea where to start. I still had everything about half way through when I checked. It must have happened when I replaced the last 24 caps on right side by potentiometers including daughter board.
Thanks

 

[cruzlink2]

I need pictures of your work to see, I had one just like this and it was the resistors that lead to the neck board connector I'll link ya my post so you have an idea.
https://x.com/Cruzlink2/status/1652760600366182401?s=20

 

[Williamcritchfield]

I need pictures of your work to see, I had one just like this and it was the resistors that lead to the neck board connector I'll link ya my post so you have an idea.
https://x.com/Cruzlink2/status/1652760600366182401?s=20

 

[Williamcritchfield]

Close up

 

[Williamcritchfield]

I need pictures of your work to see, I had one just like this and it was the resistors that lead to the neck board connector I'll link ya my post so you have an idea.
https://x.com/Cruzlink2/status/1652760600366182401?s=20

 

[Williamcritchfield]

I need pictures of your work to see, I had one just like this and it was the resistors that lead to the neck board connector I'll link ya my post so you have an idea.
https://x.com/Cruzlink2/status/1652760600366182401?s=20

 

[cruzlink2]

Follow the red connection on the connector that leads to the neck board and follow it with a multimeter in continuity to see if it leads back to the rgb amp the big mitsubishi chip on the chassis. That's how I found the broken trace on my post, if it was working before the recap most likely you have a bad trace or pad for sure.